Definition of warping:
Warping is the first step in the production process. The warping property is made to make the weaver beam of the winding. The same pin yarn count produces one fat yarn welder’s beam.
In the case of photosensitivity, warping is practically done by winding the cone or cheese of the warp beam in the same way as the yarn.
Table of Contents
Objectives of warping:
- 1) To increase wearability.
- 2) In order to increase the quality of water.
- 3) To make the cracks for reusable diseases.
- 4) To increase production
Some important parts of the warping machine:
- 1) Creel
- 2) headstock
- 3) control system
Creel: A structure for mounting a propeller on a photosensor. It is in an upright position in front of the fodder.
1) Single and creel
- a) Track creel (creel moves)
- b) Duplicated creel (Headstock moves)
2) Magazine creel
3) Travelling creel
Ingredients of creel
- Yarn clearer
- Yarn guide
- Stop device
- Package base
- Indicator
- A blower or suction fun
- Tensioners
Elements of Headstock:
- 1) Adjustable v-wraith
- 2) Measuring and marking device
- 3) Yarn speed controlling device
- 4) Break assembly
- 5) Driving drum
- 6) Stop motion
- 7) Building drum
- 8) Beam bracket
- 9) Lease rod
Warping machines (based on headstock):
- 1) Beam warping machine
- 2) Sectional warping machine
The function of the Beam warping machine:
In the process of beam warping, a single beam of wire is applied to the surface of the beam and the beam is eroded to a beam.
1) The use of beam warping to produce single-beam weavers beam is reversible. It does not require warming of the perimeter of the beam warp for the purpose of warfare.
2) It is used to make the middle part of the head. This weaver will be ten thousand feet above the end of the year. If these weavers are made into one weaver, there will be tens of thousands of weavers, but it is impossible to identify them.
Working principle of a sectional warping machine:
1) The yarn ends with a very sharp cut and make a paper sheet. This sheet Bram decays. The width of the middle of the flange-up is equal to the width of the front of the fax sheet.
2) The sheet fuck of the property wp end is a fiction bo.
3) The architecture of the first paving Nyaya tamper in a perennial fekmon sheet t errna is obtained by a perennial Gorna panyapmai rate.
4) When the first step is completed, the other part of the drummer’s answer build is lost, and the required number of points is lost for the full part of the project.
5) Fancy warps are prepared for the purpose of differentiation of property as per the plan of the project.
6) In the function sheet up, the rotation of a rupee is done by rotating and rotating the rupee uniformly.
7) The flow of the popping is done in the same way as the first popping of the popping. The size of the popping is the same as the flow of the popping. The filling of the popping is the same as the spread of the popping on the side of the poppy.
May you also like to read: